Stroller Cup Holder

thingiverse

<h1>Background</h1> My friend needed a cup holder for his stroller, but affordable options were nowhere to be found. The ones that fit were ridiculously expensive, costing around 50 EUR. So I decided to take matters into my own hands and create one for him instead. <h1>Design</h1> The design is actually quite clever. It's perforated with holes, which allows water to escape while also enabling the braiding of paracord into the design. This adds a stylish touch and provides some much-needed dampening for the cup. Unfortunately, I don't have any pictures of the printed holder or how it looks with paracord, but you can use your imagination. The holder works perfectly as is, but keep in mind that it might be a bit too large for most mugs. To avoid splashes, I wouldn't recommend using this holder without a lid on the mug. The design allows for a wide range of angles thanks to its ingenious saw-toothed fastener. <h1>Installation</h1> To install the cup holder, you'll need machine screws and nuts of the right length and diameter. You'll require three screws and three nuts in total. We used M4 screws and nuts, which is what the design was made for, but M3 might also work. First, fasten the cup holder "cage" to the mugside fastener using one screw and one nut. Make sure to check the angle of your stroller and adjust the holder before tightening it down. Then, you can use two more screws and nuts to secure the holder to the stroller.