STRIPLED BAR for Hero Me Gen5 using Dual 5015 Fans

thingiverse

This is a LED Bar for the Hero Me Gen5 when using Dual 5015 Fans and is based on using commonly available 12V LED strip. Take 2 x 50 mm LED strips (cut at the LED cut marks only) and attach to the body, Insert 2 x M3 nuts into the hex recesses on the end clips. Slip on the 2 end clips and secure the assembly between the two 5015 fans using M3 screws and the captive M3 nuts. Angle the LED bar for best illumination prior to final tightening of the screws. The bar can also be used without the end clips if desired by installing the M3 nuts into the ends of the main body instead of the clips. Wire the 2 LED strips as shown in LB4.jpg See also my other designs for use with MHg5