Strida Top Joint Pair

grabcad

This Top Joint pair allows owners/restorers of early Strida bikes (Mk1 and Mk2 from ~30 years ago) to make or buy parts which are no longer available.The pair of 'Top Joint' mouldings must be made in suitably strong, Stiff and impact resistant material (Suggest Nylon, or even Aluminium). The pair are new 3D cadded parts and will fit early (Strida Mk1 and Mk2) bikes. The pair MUST be fitted as a pair (each half would need to be modified to fit original mouldings).To make rapid prototyping cost less the 2 halves are available as a 'joined pair' . This has a tiny 1mm x 3mm joining piece (in red - see picture 'Cut Joining Piece.jpg' ). This is to be cut off before use.ADDITIONAL fixings needed:1 x M5 x 30 stainless steel, hex drive cap head screw2 x M4 x 35 stainless steel, hex drive cap head screw1 x M5 stainless steel (or zinc plated) Nylock Nut2 x M4 stainless steel (or zinc plated) Nylock Nut4mm Drill to drill holes in tubes for 4mm Screws (which replace the original self tapping screws)Mounting instructions are found in Workshop manual: https://issuu.com/mark77a/docs/strida1-owners-manual