Stream Deck Mount

thingiverse

I am not responsible for your use of this print, make sure it doesn't void your warranty, and ensure you're familiar with your printer. Any prints from me might require adjusting the scaling in your slicer depending on the shrinkage of the material or printer you're using. You can visit iamfilth.com for more information. This mount is a straightforward design for the Elgato Streamdeck. You may need to experiment with leg orientation and support placement to achieve optimal results. I used supports with an overhang angle of 75 degrees, printing the flat connector piece downwards on the build plate. The main body attaches to the legs via an M4 screw and matching nut; the screw is approximately 12 mm long but you can substitute it with a longer one if necessary. This mount features a screw hole on the flat connector piece for mounting onto a monitor riser, as I have on my desk. If you plan to use it without attachment, consider using double-sided tape or similar adhesive for stability and prevent sliding.