Stream Deck Mount

thingiverse

This is a custom-made Stream Deck mount designed for my Foxx Mount, which can be easily adapted to fit any 10-series aluminum extrusions found at foxxmount.com. The mount fits snugly at the top of my throttle mount and features an angled design, tilted at 50 degrees to ensure maximum comfort and visibility. I utilized standard 1/4-inch screws and anchors that came with the Foxx Mount, which in my case were black. It's essential to note that I initially overlooked proper tolerance, resulting in some screwing in and back out of the screw a couple times to allow for smooth spinning in the mount. If there isn't enough room for the screw to move freely, it may become lodged in the material, making it difficult to tighten the nut. Due to the angled design, I found it most convenient to slide this mount into the top of the mount first, followed by reattaching the engraved plate. Initially, you'll need to hand-tighten the bolts as there won't be enough space to use a hex key until it's almost fully inserted. Future revisions will likely include specifically designed holes for tightening those bolts. The flat part of this stand, where devices rest, measures approximately 0.6 inches in width, allowing for a wide range of compatible items, including phones, keyboards, and laptops (such as the Lenovo Yoga). This mount is intended for Stream Deck use but can be adapted to fit any device you see fit. Additionally, I've included a separate file featuring a standalone design that doesn't require a mount. Although I haven't personally printed it, this stand should work flawlessly, as its dimensions are derived directly from the original Stream Deck stand.