Straight shroud for Aero/volcano combination

thingiverse

I designed a sleek part cooler shroud for my Aero setup. It's a straightforward design with wide channels that deliver large quantities of air directly to the part. I printed this one in a new heat-resistant filament, 3DK Top Grau Hitzebestandig, which is perfect for its proximity to the hotend (5mm). Initial tests are promising - it delivers the air exactly where I want it and the shroud withstands the vicinity of the hotend so far. **Print settings used** 0.2mm layers with a 0.6mm nozzle, 260°C hot end temperature, 120°C bed temperature, fan at 33% from layer 10 onwards, printer closed without extra insulation, 3mm clear PC around, printing speed of 100mm/s, brim with 10 outlines for a larger surface on the glass, and adhesion via 3Dlac spray. **Treatment** I didn't heat it in an oven to 60°C as specified in the process for this filament. Instead, I let it cool down slowly inside the hot printer to eliminate tensions. Then, I cured it at 110°C exactly as instructed.