Storm Trooper Helmet Cabinet and Drawer Knob

thingiverse

A precision-crafted, 3D printed cabinet or drawer knob awaits. For optimal printing, position it with the screw hole facing downwards. Layer height should be set to .2mm or less, while wall and top/bottom thickness should range from .8-1.2mm. Maintain a bed heat of 195deg at 60deg for PLA prints. Achieving an infill of 25% yields a sufficiently strong result. Dimensions are approximately 40mm across all axes, though exact measurements may vary. Scaling ratios should be preserved if scaling is necessary. A 2 mm hole in the rear may require some drilling to accommodate the screw. Each knob requires roughly 1.5 hours to print, depending on your specific settings and machine configuration.