Stitch [Lilo and Stitch]

prusaprinters

<p>If you'd like to see more details, watch here: <a href="https://youtu.be/JbM4lfS2Fps">https://youtu.be/JbM4lfS2Fps</a></p> <p>Today we're bringing you a 3D printed Stitch from the Disney movie Lilo and Stitch. Stitch is such an iconic character, and it was really fun to make into a full figure.</p> <p>I modeled the whole thing in ZBrush in one sitting. It took about 6 hours from start to finish. I mostly used Dynamesh and just move things around until I get them looking right. Then I exported the model and cut off the bottom with Meshmixer so it would sit on the bed and print a bit easier.</p> <p>I've included both the cut off model and the full model just in case someone wants to print it in a different orientation. I printed it on the CR10 at a 0.5mm layer height. It came out really good on top and really bad on the bottom.</p> <p>Chelsey had to file and sand the crap out of it to smooth out the rough areas, and there were actually a few areas towards the bottom that she had to use putty to basically resculpt the geometry to make it look right. But she did an amazing job.</p> <p>After that she primed it with filler primer, used an airbrush to paint on the main blue, then filled in all the details with acrylic paints and a paint brush. Then after the whole thing was dry she sprayed a glossy clear coat on it.</p> <p>Printer: Creality CR-10<br/> Filament: BamTak Gold PLA<br/> Layer Height: 0.05mm<br/> Supports: Yes</p> <h3>Print instructions</h3><p>Unassociated tags: Lilo and Stitch<br/> Category: Creatures</p>