Still Spirits Water Flow Regulator Adjustment Adaptor

thingiverse

One of the most challenging aspects of working with the Still Spirits Water Flow Regulator is making precise adjustments to its flow regulator. By doing so, it becomes significantly easier to make tiny tweaks and also mark key reference points you identify during the process, such as your starting position, in order to prevent unmonitored starting overrun when the boil kicks in. This model is remarkably straightforward, even for someone with limited experience designing in 3D like myself. Aligning the flat surface of the STL file with your bed is a simple process that requires no supports. An infill rate of about 15% should suffice as long as you use 3-4 top and bottom layers, along with 3-4 wall perimeter layers, to ensure sufficient strength within the inner hole. You should be able to easily manipulate this print over the dial, but I recommend warming up the PLA slightly beforehand so that it conforms smoothly to the spindle as you place it on. For optimal accuracy, apply a strong adhesive such as CA or other hard-setting glue to secure the print to the spindle, preventing any potential flexing or movement.