Stiga Play Off Hockey control rod gear

thingiverse

The peg holding the player model (goalkeeper) on a Stiga Play Off table hockey game was broken, and I found markkuhe's model as a good start. He did the hardest part (the gear), and I modified a few things: - As the hidden part of the gear (that is connected to the metal rod) as intact, I kept that and this model is only the vertical gear+rod+peg - I separated the gear from the rod, and made a square hole to fit the extended rod. - The square rod is 5 mm longer than the gear, so it can be secured from underneath, if needed. The fit is tight however, so it is probably not needed. - My game has a longer and wider through-rod that the original model - The rod is lied down on it's side for better printing, both for printing stability but mainly to have the filament run along the rod for strength. The downside is that the underside of the rod is flattened slightly, but it worked fine anyways. - The peg width was adjusted slightly, as it was too tight for my player models. The peg is also slightly off-center due to being on it's side, but it didn't seem to matter much. - The collar holding the rod on top was too small for my control arm, so I made it wider. I used Tinkercad for all modifications.