Sticky note wall mount

prusaprinters

I lose my pen and sticky notes on my cluttered desk all the time. So the simple solution is to wall mount a sticky not and pen holder. PrintingInfill should be set between 50-90% (I used 50% for mine)The print should be printed standing with the front pointing upwards.Supports are not needed but can be used.Items needed2 - #6 phillips screws2 - #6 drywall anchors1 - Sticky note wall mount (print)Screwdriver #2 pencilDrill and bit (for anchor)Choice in installation tools is up to you, I like to use power tools. InstallationUse a small level (or the app on your phone) and position the mount on the wall until levelOnce you are level take the #2 pencil and insert it through the screw holes on the front and to the back to mark your drill points on the wallDrill and set your drywall anchorsPlace and start both screws in the mountPlace your wall mount over the anchors (circular recesses in the back of mount for alignment. Tighten your screws and verify the mount is flush and secured to the wall.Add sticky notes and pen of your choosing.Sit and admire your new sticky note holder.