Stickvise jaws for MHP30

prusaprinters

<p>These are replacement stickvise jaws that you can use to hold a PCB at the correct height for use with the Miniware MHP30!</p><p>I generated them with the official stickvise jaws OpenSCAD script, which is available here: <a href="https://www.stickvise.com/hacks/parametric-jaws">https://www.stickvise.com/hacks/parametric-jaws</a></p><p>Note that your PCB will get very hot when it is being heated, so choose your print material appropriately! Definitely not PLA! Personally, I used ABS and then covered each jaw in a layer of polymide tape, followed by a layer of copper tape. Hopefully this will be enough for the jaws to take the heat, but if you do this and it all melts into a big mess then it's not my fault!!</p><p>For assembly, you can just reuse the bolts that hold on the original jaws. You will need a long screwdriver though.</p>