Stick Holder for 3-Wheel Rollator (and others)

cults3d

This is a walking stick holder for a Rollator/Walker. It was designed for a 3-wheel Rollator branded "Days", but it may fit others. This was designed to suit the following measurements: * Rollator tube diameter 24mm (bottom part) and 19.1mm (top part) * Stick diameter 23mm The commercially available versions will only work with vertical tubes. However, with this version you can adjust the orientation of the lower "cup" part in increments of 90, 45 or 22.5 degrees, so it will suit models with horizontal, vertical or even sloping tubes. Hardware required (for the version as pictured): * 4x M4 x 10mm Socket Head Cap Screws * 4x M4 x 8 x 6 Heat Set Inserts (embedded nuts) * 1x M6 x 12mm Socket Head Cap Screw * 1x M6 Nut If you don't want to use the Heat Set Inserts, I've made a version for regular M4 nuts too. In that case you would need the files with "m4_nut" at the end of the filenames. There are some other designs on Thingiverse, which may be useful if you need to mix-and-match parts to suit your model: * https://www.thingiverse.com/thing:1604837 * https://www.thingiverse.com/thing:3238527 * https://www.thingiverse.com/thing:2477851