Steyr Aug Body Pin

thingiverse

Human: Replacement Receiver/Body Pin for Steyr Aug You Will Need: 2x Screws Approximately 4mm Long, 3mm Diameter (Countersunk Head) 1x Spring Approximately 3.8mm Outer Diameter, 7mm Long Notes: The Screw Holes Are Slightly Undersized to Allow for Tapping a Thread with Screws; It Is Essential to Back Them Out Half a Turn Occasionally During the First Assembly. This Model Has Been Broken Down into Three Parts to Facilitate Easier Rotation in Your Slicing Software. Keep in Mind That This Design May Not Fit Immediately, as My Models Often Provide a Close but Not Exact Match. All Measurements Were Taken Directly from an Original Part for Accuracy. If You Encounter Any Issues, Please Do Not Hesitate to Reach Out. Print Settings: Printer: Anet A8 Rafts: Irrelevant Supports: Yes Resolution: 0.1mm Infill: 30% Notes: It Is Advisable to Print at a Resolution of 0.1mm Due to the Sensitivity of This Part, as Any Slop May Cause the Receiver to Shift Back and Forth in the Aug's Stock. Thirty Percent Infill Has Been Estimated; However, You May Want to Consider Increasing It to 100% for Added Strength. If the Part Breaks, the Receiver Will Slide Out of the Stock and Possibly Fall on the Floor.