Stern Insider Connected Flush Coin Door Mount

thingiverse

This is a new design of the coin door mount for Insider Connected. This model is split into two pieces in order to print a raised center section to be flush with the rest of the coin door - the way it should be! Print the pieces separately, no support and glue them together with your favorite plastic cement. It should snap together with the alignment pegs. If your printout is a little rough, you might have to clean up the holes to get it to snap together. Optionally you can cut a thin (.080 or .092) Plexy and put it in the back side before installing the insider connected scanner to the plate. Shown in pictures with the protective cover still on the plexi. A couple drops of glue carefully placed will hold the plexi in place and protect the face of the IC module from scratches and fingers! IC scanner module mounts to the plate with two #4-1/2 inch sheet metal screws. Mounting upside down so cable connection is on top will make routing the cable easier. Does not need to be painted.