Sterilite 20Qt (19L) Drybox

prusaprinters

<p>This is the simplest and quickest to print dry box I can imagine. It holds 3 spools. You need only the following:</p> <ul> <li>Superglue</li> <li>Two prints of (SteriliteHolder.stl)</li> <li>One Sterilite 20Qt (19L) gasket box available everywhere! <a href="https://www.target.com/p/sterilite-20-qt-gasket-box-clear-with-blue-latches/-/A-15066036">target</a>, amazon, <a href="https://www.walmart.com/ip/Sterilite-20-Quart-Gasket-Box-with-Clear-Base-and-Lid-6-Pack-19324306/633637534">walmart</a>, etc</li> <li>1/4 inch or 6mm rod. 14 inches or 35 cm length <a href="https://www.homedepot.com/p/Everbilt-1-4-in-x-48-in-Plain-Steel-Round-Rod-801587/204273972">homedepot</a>, amazon</li> </ul> <p>optional:</p> <ul> <li>Some kind of push fit connector and tube amazon</li> <li>Desiccant</li> </ul> <p>Assembly instructions.</p> <ul> <li>Apply glue to your printed parts and stick them to either end of the box. Keep them in place with a piece of tape while the glue dries. It's important they are roughly level and upright</li> <li>Measure your rod and cut it to length with a hacksaw or whatever means you need.</li> <li>Done</li> <li>Optionally drill a hole through the box and screw in your push fit connector. (PushFitNut.stl)</li> </ul> Category: 3D Printer Accessories