Stepper motor damper V2.0

thingiverse

Hi everyone, I'm TPU stepper motor damper. This project is designed to make your printer extremely quiet, allowing me to print day and night without disturbing anyone, even if my printer is located near my bed. I created this so I wouldn't have to wait for the original dampers to arrive from China; they're still stuck on a slow boat there. Here's what you'll need for this CR-10 printer setup: 8x M3 nuts (insert these into the damper from the inside) 8x M3 bolts, 5mm long (for thinner stepper motor side) 4x M3 bolts, 8mm long (for mounting X axis sensor on CR-10) 4x M3 bolts, 6mm long (for attaching to Y axis support) When installing the damper, be careful not to over-tighten your belts. This can cause the support to bend and the belt to slide towards one side. Instead, tighten it just enough so that the belt won't slide. I hope you enjoy my design.