SteinMore DeltaMax

thingiverse

This is my version of the following Thing: https://www.thingiverse.com/thing:923830. You will need parts from the above, specifically the Lower and Upper corners only. Use 2020 for the uprights (1000mm long x 3 units). For the base, use 2060 (400mm long x 3 units), and for the top, use 2020 (400mm long x 3 units). The effector spacing between rods is 60mm. I used 10mm Neodymium magnetic balls glued to the effector and carriers. Use the "M5 allen cap screw mounts" for a magnetic setup. Alternatively, you can insert 10mm x 3mm bucket style magnets into the mount and rods. Then attach the Magnetic balls to the rods. Only after that should you glue your magnet balls to the Effector and carriers. Otherwise, you will end up with opposing magnetic fields, and the effector will release at the slightest touch. The total length for the rods is 400mm on my setup. Alternatively, you can use this effector and the "BallJoint mounts" to convert the printer to Ball Joint/Rod end. https://www.thingiverse.com/thing:1015846 See it run...:https://youtu.be/DNQ4mvcmFyU Sorry for the funky orientation of the STL files – Fusion tends to turn everything on its side, and I'm not happy about it. Update: Add support for the top of the Printer: Delta Top Support Arm x 3 units and Delta Top Support Centre x 1 unit. Assemble the three parts (you need to mark drill the centre piece). Clip it in – no need to screw it to the 2020 profiles. This thing goes in with a fight and a tight fit. Update2: I added Crossbrace. Print three – one for each upright. I used 10mm Aluminium tubing to connect the three to create a brace.