Steggy Guitar Pick Holder - Fixed Bottom

thingiverse

Despite looking perfectly flat, the original .stl that I remixed this from had a small section on it's front right arm that was slightly lower than the rest of its stomach which was causing the rest of the body to print in mid air by about 1 layer. In some slicers, you can just drag the model down a little bit and it'll ignore anything below the build plate but not all slicers do this. I converted the .stl to a solid in Fusion 360 and deleted bottom facets until it was one facet. The model now imports flat on the build plate.Even though this model was made for the Tortex 1.0mm picks, I was able to force the 1.14mm ones in and they hold in firmly.