Steelseries Kana V2 Mousewheel

thingiverse

I got my mouse by dropping it one too many times and finally snapped the thin rod that keeps the wheel in place - it's just 2mm wide after all, made from cheap plastic.\n So I took matters into my own hands and came up with a replacement that matches it almost perfectly. \n\n \n \n Step-by-Step Instructions I printed it on high speed at 30mm per second and set the layer height to 0.1mm using Veelmen Indigo PLA, heating the hotend to 190c and keeping the bed temperature steady at 60c with my Printrbot Simple Black.\n Luckily, the print came out fine except for one minor glitch: a small smudge on the end of it.\nIf this happens, you can fix it like I did - grab a sharp knife and give the rod a good 2 minutes of hacking until you get a hexagon-shaped finish.