SteelSeries Arctis Pro Wireless IR Track magnetic clip

thingiverse

This is a magnetic ear plate replacement IR Track clip for a SteelSeries Arctis Pro Wireless headset. I use it for DCS and I'm happy with it! It can be installed and removed from the headset the same way as the original plates, no modifications required. It runs on a small Lipo battery and can be recharged by usb. the battery switch isolates the battery and the power switch isolates the output (leds). the Solidworks files are in, fell free to modify, improve and share! Parts are glued in place with your glue of choice for more or less disassembly capability... I used a mix of epoxy, cyanoacrylate and multi purpose glue. You will need soldering equipment, 28AWG or so wire and heat shrink tube. Components required: These are fairly standard and can be found on Amazon or Banggood. - 2x 10mmx2mm magnets - 3.7v Lipo, 600-1000mAh, 9x25x47mm https://banggood.app.link/uRx7P1b59jb - micro usb breakout board https://banggood.app.link/H8xtn4149jb - 3.7v charge / discharge controller https://www.amazon.com/dp/B07PZT3ZW2 - 3x SFH485P LEDs - 6.8ohm resistor - 300mA polyfuse - 2x micro vertical slide switches https://www.amazon.com/dp/B07BMPVDMD I followed this guide to set it up: https://www.reddit.com/r/starcitizen/comments/60uejd/completeish_opentrack_diy_trackir_guide_20/ This was inspired by: https://www.thingiverse.com/thing:3470378