Stearing Wheel Knob

thingiverse

I've designed this knob for making it easier to handle sharp corners and roundabouts while driving a manually shifted car, that's basically it. To complete the assembly you'll need an M6 bolt and nut and an M4 bolt and nut (or similar). Print Settings Printer: Tevo tarantula Rafts: No Supports: Yes Resolution: 0.2 Infill: 50% Notes: Printed in PLA, 195/48. First layer 200/55. Post-Printing Extra material. For my assembly I used an M6 bolt and nut and an M4 bolt and nut too. I also used some two layers of 1mm foam sheets on part A and B each. Assembly Remove all supports and make sure that all parts are rigid. Use some grinding paper if the parts don't fit directly. I made the "plug" a little bit smaller for the uploaded design so everything should fit. Insert the bolts and nuts (if the nuts don't fit you can heat them up a bit but be careful not to deform the model). Stick the foam sheet on pieces A and B. Attach to steering wheel.