Steam Deck Stand for Anker 8 in 1 usb-c hub (553 A8380)

prusaprinters

<p>Simple remix of the <a href="https://www.printables.com/prints/150311-steam-deck-stand-with-anker-8-in-1-usb-c-hub">stand by Nestea</a>&nbsp;<br><br>Anker produce also a very similar hub, confusingly commercialized also as 8-in-1 that has two hdmi ports.<br><br>This hub is also known as <a href="https://www.anker.com/products/a8380?variant=37438571741334">“media hub”, model “553” or “A8380”</a> (you can find this last model number on the back of the hub if you want to be sure)<br><br>I've simply changed the original model (for the <a href="https://www.anker.com/products/a8383">model 555</a>) to make the slot slightly larger.&nbsp;<br>the 555 should still fit but you would be better off with the original design.<br><br>Things to potentially improve and remarks after use:</p><ul><li>extend the rear tail (when the deck is not in place the weight of hub is so shifted that the whole thing is about to tilt and fall backward. depending on how you route your cables that can make it even worse)</li><li>the elastic that hold the hub in place when at rest cover one of the two usb ports (you can still use the port by moving it aside but moving the slot slightly higher would allow to use all the ports&nbsp;</li><li>you might or might not like the notches that perfectly fit in the rear screw holes.<br>(+ the hub is very firm once “engaged”, - it takes few tries to place the deck correctly)</li><li>you might prefer a more upright angle</li></ul><p>&nbsp;</p>