Steam Deck Dock/Display Stand

thingiverse

My take at a dock/display stand for the Steam Deck. The back logo is intended for adhesive rubber cut in shaped of the logo for added grip but that has proved unnecessary with testing. I have included the logo to be printed as an insert in any color you like. Version 3: New shorty model available. I sunk the base as far as I could and added a very short backrest. I have found that groove provide plenty of holding power and the backrest isn't as necessary as I originally thought. I have not tested this model yet. But I am fairly confident that it will work. I have uploaded a version with a thicker back support. I have remade the entire model for better printing. Supports should now not be needed with good cooling. I have also included a nicer cutout for my hub which is Cable Matters model 201048-BLK. Mount on the back with double sided tape. A right angle is required given the sharp bend. I have included the standard model version. I am planning one for the Anker 7in1 hub but playing with some ideas on how best to accommodate it. It is a lot guess work since I do not own the hub and cannot get accurate measurements with calibers. Version 2: I have hollowed the base to allow a usb c hub to be stored under it. The current clearance is 10.86 mm but I can make it taller if there are any hubs that need it. The image I have included is an example of 2 hub locations. There is a model with a side hole and without. The hub on the back is a Cable Matters model 201048-BLK that I had purchased for my deck. I have included a version with a cavity that can fit the Anker 7in1 hub. It does come closer to the vents but does not block them. The cable is fed out the hole and you should secure the hub with double sided adhesive tape. I have uploaded a cut model for smaller printers like the ender3. Its a simple splice of both ends. I have also uploaded a step file version if anyone wants to mess with it. Truthfully, the model is bit messy at this point since I didn't plan on hollowing out the bottom originally. I will have to redo everything from scratch at some point. Added Steam Deck logo as a printable stl. It is 3mm thick and will protude 1mm from the indent on the back support. There is a png template of the logo as well that is sized at 300dpi 77.469 mm tall. If you wish to cut it from foam or other soft material.