Steam Deck cable strain relief

prusaprinters

UPDATE 14.01.2023Reddit user ar99644 sent me a remix as he uses his power supply in combination with the strain relief  to the other side when he plays in bed,  so he mirrored my design  to the other side. Like this the cable should remain tucked under the clamp when you place it under the side your power supply cable is coming from. Thanks for that Buddy ;)  Simple but effective cab le strain relief for your Decks original charger.Simply clips on and your good to go.Printed in PLA no problems after several hours of high demanding AAA games.Print with support everywhere. (one support is already included in the object file I had to add because cura did not feel like adding it automatically)the support in the middle section of the fan inlet hole comes off easily if you use some pliers and gently wiggle the support our from the back, it comes off clean in one piece. ( see picture)Pros&Cons: ( by dzikakulka thanks mate ;) )  No moving partsDoes not sideslip thanks to tiny notches grabbing a vent lipHas a small handle/whatever at the bottom for easy putting on and taking offFits any plug because there's clearance around port holeRelieves strain through a cable clip on the back so you can adjust the slack yourselfAlso above conveniently routes cable down the backprint with 1.2 mm outer wall thickness and 15% infill, support material everywhere! for best results!