StealthySwiss for Creatlity Sermoon D1 with Linear Rail mod

thingiverse

***WARNING*** THIS IS A WORK IN PROGRESS!! THERE ARE NO WARRANTIES EXPRESSED OR IMPLIED BY USING THESE PARTS! YOU ASSUME ALL RISKS BY DOWNLOADING AND USING THESE PARTS! NO TECHNICAL SUPPORT WILL BE GIVEN AS WELL SO DO NOT CONTACT ME ASKING ME HOW TO DO SOMETHING! This is a remix/mod of the StealthySwiss by RomaAquatics that I made to fit my linear rail extruder that I surgically grafted onto my Creality Sermoon D1. Though the parts are meant for the Sermoon D1 that's been modded with a linear rail, the parts may still be useful to anyone else looking to add this mod to their linear rail version of the Micro-Swiss extruder. Here is the linear rail mod for the Sermoon D1 that this can work on conjunction with: https://www.thingiverse.com/thing:5390692 The main change is to the mounting bracket in that there simply isn't enough room in the Sermoon D1 to add the CR-Touch probe to the left of the extruder as well as you need every bit of available space just to make it work as it stands today. The fan shroud included here has been slightly modified to allow for wiring access and the heater block shroud has been modified for screw clearances with the mounting bracket. Specifically for the D1 (but could probably be used with other printers) is a limit switch mounting bracket. As every mm of space needed to be used on the extruder housing, I had to get creative with placing the y-axis limit switch. By placing it behind the assembly it helps keep the switch from breaking but it also utilizes the space that would otherwise go unused. The limit switch mounting bracket attaches with an extra long screw through the front of the entire assembly. The center pin of the switch will need to be removed and ideally you would also install two small screws to keep the limit switch in place. The main screw holding the assembly keeps it from moving backwards anyways but the small screws through the side will keep the switch from falling forward. Again ideally you would also install two small brass heat set screw inserts as well but a dab of glue works too. No other files are included. I have not released the other parts to complete the linear rail retrofit to the D1 as I am still working on them.