STC-1000 easier print

thingiverse

I tried printing the model on my printer, but it was totally unprintable due to screw tabs floating in mid-air. They were being printed with the right extruder and then hit by the left one, resulting in a mess. Also, the holes wouldn't come out properly round if I printed them vertically. To fix this issue, I cut off a few layers from the bottom of the model, only affecting the feet. I also rotated the pieces so that they were flat on the build plate and split the model in two to make it easier to print. Now, the model needs some supports to be printed, as indicated by the screenshots. However, I have successfully printed both halves and they fit perfectly with the STC-1000. I also added a universal box generator remix to the design, which is not yet tested. Unfortunately, it doesn't offer customization options without using OpenSCAD.