Static Hook

This is a small hook to hold a Ninja Coffee measuring cup.
I was using a commercial hook to hold the measuring cup but it was difficult because to use because the little wire hook would raise when I tried to remove the cup.
This one is modeled after the commercial hook and I use the two-sided tape to mount it to the side.
I needed to drill a small hole in my measuring cup handle in order to hang it on this hook.
I think this can be improved if I were to not use a curved hook shape but more of an angled hook so the cup sits flush at rest and probably will make it easier to use too.
Print Settings
Printer Brand:
Ultimaker
Printer:
S5
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
100%
Filament:
Ultimaker Tough PLA, PLA
Black, Icelandic Blue
Notes:
I print this sideways to the long fibers (grain) runs towards the tip of the hook. I don't expect much load but this should provide maximum strength in the load direction.


Category: Kitchen & Dining