Static Hook

prusaprinters

<p>This is a small hook to hold a Ninja Coffee measuring cup.</p> <p>I was using a commercial hook to hold the measuring cup but it was difficult because to use because the little wire hook would raise when I tried to remove the cup.</p> <p>This one is modeled after the commercial hook and I use the two-sided tape to mount it to the side.</p> <p>I needed to drill a small hole in my measuring cup handle in order to hang it on this hook.</p> <p>I think this can be improved if I were to not use a curved hook shape but more of an angled hook so the cup sits flush at rest and probably will make it easier to use too.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Ultimaker</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>S5</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>100%</p></div> <p><strong>Filament:</strong> Ultimaker Tough PLA, PLA Black, Icelandic Blue</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>I print this sideways to the long fibers (grain) runs towards the tip of the hook. I don't expect much load but this should provide maximum strength in the load direction.</p></div> </p></p></p> Category: Kitchen & Dining