Starship Super-Heavy BT-80 Model Rocket 1:136 (09-27-2019)

thingiverse

FULL DISCLOSURE: I haven't flown this yet. Printed files must be combined with two lengths of BT-80 model rocket tubes (66mm). The Superheavy BT-80 model measures 42.5cm, the same length as my Fincan V2. The Starship BT-80 model stands at 10.5cm tall, while the updated version, Starship BT-80 Mk3, is a mere 10cm in height. Two Utility Tunnel covers must be printed and made slightly longer to trim them down to match the length of each BT-80 tube for the starship. Additional internal tubes and centering rings will be needed depending on the motor chosen, requiring you to devise a recovery method. I have successfully used these affordable chutes in previous rockets: https://www.youtube.com/watch?v=CISZ7RUye5w. This model is relatively simple; however, the heat-shield side profile for starship is off, so I'll mark this as a work in progress. The designs are fluid at this point but with some nice chrome and black paint, it should look pretty good. I would like to credit my inspiration to: https://www.thingiverse.com/thing:3192548. There are some great examples of internal design on that site. NOTICE: If you downloaded the version one Fincan, your tube length is as follows: The Superheavy BT-80 model measures 45cm.