Starlink Wall Pass Through Seal

thingiverse

I printed and used the awesome Starlink Cable Wall Pass Through created by RickJ19Zeta8. After the last winter storm, my Starlink stopped working and Starlink insisted that my cable was bad. I replaced the cable (it did not fix it). Because I had used silicone in the conduit to protect from insects entering my attic (I'm a beekeeper and I don't need my swarms in my house) I had to completely destroy the wall pass through AND the cable to remove it. I printed this seal out of flexible filament (40D hardness) and it works like a champ. After I had it already installed, I thought I should have shared it. Instead of climbing back onto my steep roof to take a photo, I used my broken pass through to demonstrate. Simply print this piece in flexible filament, slip it over the cable, and insert the tapered end from the outside. It is very snug by design. Insert until the flat side is flush with the pass through, install the cover, and enjoy knowing that bees will not find that opening attractive as a new place to live.