Starlink v2/3 pole mount

prusaprinters

<p>This is my solution to a very specific problem, when traveling with my Starlink dish I didn't have many options to raise the height of the dish to clear my trailer. Since the Airstream doesn't have a traditional roof or ladder system, I found a flag pole mount that I can put under my front jack, and an aluminum pole that is normally used for concrete screeding. I designed 2 parts one for the top of the pole to emulate the normal base of the Starlink dish, including the keyway and the release button, and the second part to adapt the 1-3/4 inch pole to the 2 inch base plate.</p><p>&nbsp;</p><p>There are some small tweaks I need to make to tighten up some print tolerances as the pole moves a little in high winds, I think a layer of gaff tape might solve that issue quicker than test prints.&nbsp;</p><p>&nbsp;</p><p>Commercial parts used</p><p><a href="https://www.homedepot.com/p/Anvil-6-ft-x-1-3-8-in-Aluminum-Swaged-Button-Handle-57544/300997955">https://www.homedepot.com/p/Anvil-6-ft-x-1-3-8-in-Aluminum-Swaged-Button-Handle-57544/300997955</a></p><p><a href="https://www.amazon.com/gp/product/B013XQSETQ/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&amp;psc=1">https://www.amazon.com/gp/product/B013XQSETQ/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&amp;psc=1</a></p><p>&nbsp;</p>