Starlink Dishy DC Power Supply PoE Injector

thingiverse

This is the 3D Printed Case for the [Starlink Dishy DC Power Supply and PoE Injector ](https://boondocker.io/products/dishy-rv-power-supply?discount=everlanders&rfsn=7157873.4b72b38&subid=thingiverse). To embed the logo into the front of the case I'd suggest placing both, the logo STL and the case STL of your choice face down in the slicer, then adjusting the X and Y of the logo so that it's perfectly aligned in the recess in the case. and then save it as a project. It helps to preview the print and slide the slider down to the first layer. Then you can remove the case from the print bed and slice the Logo, and Print in your darker color. I'd suggest printing this 2 layers deep and slowing it down to 20% of what you normally would. Print with a skirt to equalize the filament flow and then pick off the skirt and fuzzies before printing the case. I used a mini torch and toothbrush... After the logo was printed I immediately set the printer to preheat the bed to keep it hot and hold the small parts as I got the next job ready. Filament change as normal... Then you can reopen the project and remove the logo and then slice the main case. I'd suggest setting combing to "all" and z-hop on retract set to 0.5mm so that the nozzle doesn't hit the printed logo. The video showing the design and printing can be seen here: https://youtu.be/RlENmAikSQQ EDIT: Added the updated rear cover with the cutouts to suit the new Rev 1.4 Layout