Starlink Adapter for Harbor Freight flag Pole

prusaprinters

Adapter to allow the end of the Starlink Dish to be mounted into the end of the Harbor Freight 20 foot flag pole.   You will need to remove the plastic cap on top of the pole in order to slide the adapter in place.  When I built mine it was fairly tight and no glue was necessary (used a rubber mallet and wood block to protect plastic).  If not a good fit - scale up/down 1% or so and see if that works.   BTW, I was able to still use the lower portion of the pole as a flagpole - use hardware from the cap and flag mounts and with a little ingenuity to flag ring can still be used.  I riveted a couple of rings to the flagpole that prevented the flag ring from moving up and down - about 6 inches from the top of the pole.