Starbucks Random

thingiverse

This Thing was created using the Customizer tool. To learn more about how it was made, check out this page: http://www.thingiverse.com/apps/customizer/run?thing_id=99020. Options Used: Instructions are found below: You used these options to make this Thing: Sleeve is set 0 units above bottom of pattern Color of Thing is a bright fuchsia pink color Diameter of bottom of Thing is set at 59.5 units Thickness of lines in the design is set to 3 units Number of revolutions (pattern spins) was set to 8. Thickness of outer edge of pattern is 5 units thick Overlapping material outside of printed object is 5 units wide. Sleeve makes up 95 percent of height. The number of sides of pattern are 11 in all. Design size is set at a full 17 by 17 square units. Resolutions per inch of printed design were set to 30 points per line on a full high-resolution print job. Thickness (of plastic layer) used for printing is just two single layers thick. Diameter of the top edge of pattern is now a very large diameter of 82 units wide The whole pattern was turned in the machine 43 degrees during manufacture process. Finally the final product measures exactly 135 units from one edge to opposite, fully-printed corner of design, at bottom (of what is actually sleeve, as per instructions above)