Star Wars Rebels Starbird Logo Magnet

prusaprinters

<p>You can glue a 10 x 1.5 mm round magnet in the base.</p> <h3>Print instructions</h3><p>Recommended infill angle: <strong>45°</strong></p> <p>Low speed and high temperature will create a shiny top surface.</p> <p>There are "holes" inside the model to make some of the top layers more uniform, and they were created with <strong>0.2 layer height</strong> in mind.</p> <p>If your top surface is not flat &amp; shiny and you see scarring, then make sure to check this guide: <a href="https://bit.ly/2UtN0I1">https://bit.ly/2UtN0I1</a></p>