Star Wars Galaxy's Edge Kyber Crystal Display

thingiverse

I designed a kyber crystal container that will hold Galaxy's Edge Kyber Crystals. I used Figure Works's kyber crystal container as a base and I scaled it up and added some stuff. There is the main piece, and one is smooth and one has lines down the side so you can choose which ever one you like better. That screws into the cap because I plan on making more adaptations that you could just screw into the cap so you can save on time and filament. Lastly there is a crystal divider that goes into the slot in the main piece. I would suggest buying rubber grommets and gluing them to the slots wall to hold the crystals in place securely. You will need to use supports on the main piece and the cap. I recommend orienting them so that the threads are facing up for both the cap and for the main piece. The crystal divider can be printed on its back with the curved divisions facing upward. That piece does not need supports. ALSO VERY IMPORTANT! I would highly suggest cutting the pieces below the threads to make sure they fit so you don't waste a bunch of time and fillament. I have added a new piece which is the short crystal container. This is another way to display the crystals vertically around the cylinder. Whats great about this piece is that it can screw into the cap which works for both the short and tall displays. You will still need some rubber grommets glued into the top and bottom to hold the crystals securely. If you happen to make this please leave suggestions for improvement in any way. Also add it as a make under this post.