Stanley Cup

thingiverse

This is a greatly enlarged version from http://www.thingiverse.com/thing:536259. The total height comes out to about 8 inches (200mm). I've significantly increased its size and turned it on its side, separating the cup (top) from the stand (middle) and hollowing out the stand so that it can be printed without any supports and use less filament. Some minor filing might be required for a precise fit. The top (cup part) will still need supports but only inside them. Avoiding outside supports helps keep the exterior 'clean'. I've made a slight adjustment to the middle section to make the mating hole easier to sand if needed, I've also added a solid bottom to make gluing easier. For this creation, I set the top at .1mm, the middle at .2mm and the bottom at .3mm. To finalize it (in the picture), I filled the middle with sand. Then I glued the top on. Next, I spray painted them silver, leaving the bottom unpainted. Finally, I glued them to the bottom.