Stand for Two HA210NO6 MOSFET Modules and Fans

thingiverse

A stand is designed to hold two HA210NO6 MOSFET modules and two 40mm fans in place. I located the MOSFETS on Amazon at this link: https://www.amazon.com/gp/product/B07TWL385B The fans are likely not required, and their mounts can be removed if desired. However, a cut-out is available on the stand that matches their dimensions, allowing for attachment using CA glue to secure them side by side within the cutout. I attached the mounts as seen in the photos but chose not to install the fans since my Ender 3's heatsinks never get warm enough to necessitate additional cooling measures when installed. The MOSFET product description specified the following details: Dimensions: 70 x 45mm, approximately 2.76 x 1.77 inches Distance between holes: 62.8mm x 37.8mm, approximately 2.47 x 1.49 inches Supply/Operating Voltage: 12V-50V (12-24VDC recommended) Max Current: 30A (Enhance heat dissipation) safe for prolonged periods. Ensure active cooling of the heatsink. This design was created using Tinkercad and can be edited online at https://www.tinkercad.com/things/guBrK1u7ZF6.