Stand for the Kreg R3 jig

thingiverse

I Made a Stand for My Kreg R3 Jig Inspired by This Triple Pocket Hole Jig Stand (https://www.thingiverse.com/thing:2816165). However, That One Was Designed Specifically for a Printed Jig and I Already Had the Kreg R3. To Use It, Simply Remove the Round Clamp Plate from the R3 and Insert It into the Stand, Which Allows You to Work with Boards Ranging from 1/2" to 2x4 and Utilizes the R3's Built-In Sizing Guide. I Also Made Use of This Clamp (https://www.amazon.com/gp/product/B004K60H08/) but Replaced the Tip with a Longer 5/16 Inch Bolt, Measuring 1-1/2 Inches Long Including Just the Threaded Part, to Enhance Its Adjustability. The Stand Was Printed in PLA at Over 60% Infill and Features Two Smaller Printed Side Pieces That Assist with Dealing with Wider Boards. As Shown in the Picture, the Clamp Needs to Be Mounted Slightly Higher Than the Stand and Spaced Apart to Accommodate a Range of Board Sizes. I Recently Built an Enclosure for My Ender 3 Pro Using This Setup and Found It Much Easier to Use the R3 in This Way Compared to the Old Method.