Stand for Teenage Engineering OP-1 Synth
thingiverse
This is a straightforward stand and screw kit. Ensure it's not visible from the front; print two of each part for both sides. Position the recess on either the upper or lower rubber of your OP-1 at your discretion. However, refrain from overly tightening the screw as it may break due to its plastic composition. For printing, use a thick wall (1.5mm in this case) with 0% fill for the stand. To prevent hot end melt damage on the screw's thread, adjust the print speed towards the top layer. Also, be cautious not to over-tighten the thumbscrew, as it may cause the head to break off from the stud.
With this file you will be able to print Stand for Teenage Engineering OP-1 Synth with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Stand for Teenage Engineering OP-1 Synth.