Stand for PCKT One Plus and accessories

prusaprinters

<p>I got tired of my PCKT falling over when the table it was standing on was bumped and I couldn't find any other stands that were designed for it so I decided to throw this one together.&nbsp;</p><p>It's a super simple design, holds the vape well enough to not fall over but loose enough that you can just set it in quite easily. The vape rests at a 10 degree angle which I've found helps keep it sturdier than if it were standing straight up. Also fits 5 standard 510 carts with a bit of wiggle room for some slightly wider carts. There is also a section in the front that allows storage of smaller accessories such as the magnetic adapters which are a bit too short to put into the cart holes.</p><p>&nbsp;</p><p>No supports needed, everything has enough clearance that resizing shouldn't be necessary</p>