Stand for Drayton Digistat 2/3+RF Thermostat

youmagine

This is a versatile base for the Digistat 3+RF (or 2+RF) wireless thermostat. Normally, the controller would be wall mounted, but we prefer to move ours around from time to time, so I designed a base for it. The base consists of two parts that are bonded together with adhesive (I used superglue, although any suitable adhesive will work). These two parts fit together in only one way, making it easy to get a precise alignment. The base attaches to the back of the controller using lugs that match up with the screw holes and clips that hold the base securely in place. Likewise, it can be easily detached if necessary. For proper attachment, the PLA needs to flex slightly to snap into position. Both parts can be printed quickly at a low quality setting (which took approximately 30 minutes on my Ultimaker 1).