Stair Jumble Vase

myminifactory

My wonderful Patreon supporters get this model free! :) Vase mode printing, as we know, has a particular constraint in that angles just can't be too far from vertical, and that's in both the angling-up and angling-down directions.  There just isn't enough overlap between lines past a certain point, and the results are a mess!  I'm pretty conservative about those angles, and generally keep it to about 45 degrees. Now, this made life a bit difficult when I set out to model some vase mode staircases!  Obviously we can't have horizontal landings in the world of vase mode, nor can we have horizontal steps.  Since stairs are generally full of right angles, this also meant we couldn't have vertical bits either.  So, as you can see, everything's tilted on angles! Read the rest of the original writeup on Patreon here: https://www.patreon.com/posts/92694712