SSDS3 Gasket for TurboGrafx

thingiverse

Print with no support. The H-shape piece goes under the PCB. You may want to fix it by driving some of the screws from the top side just to make it less fiddly while you try to fit the PCB into the bottom piece. It is essential to install this piece so you don't over-tighten the screws and break the original shell later. The original back panel goes on together with the PCB. You won't be able to put it in after the PCB is seated. The side gasket should fit snugly with your bottom shell. If it would go in, your printer probably has a squished bottom layer, you will have to trim the bottom perimeter to make it fit.