SS 7gal Chronicle fermenter feet

thingiverse

The SS Brewtech 7gal Chronical fermenter arrives with rubber feet that fit into the bottom of its three legs. However, these feet often split at the edges and must be replaced. To address this issue, I created alternative feet designed to accommodate the fermenter's legs while utilizing the original rubber feet. I trimmed the rubber feet with a utility knife to ensure they fit snugly into the new feet. A printed rod with threaded ends is included to pass through the new feet, secured by a knurled nut that helps tighten them in place. After printing this rod and nut, you may need to run an M6 tap and die nut over the threads to make assembly easier. Occasionally, the bottom of the fermenter's legs develops a slight burr, requiring light filing to smooth out the edges for a snug fit with the printed feet. To print the main body of the new feet, use support settings in Cura. I recommend the following: * Support Placement: Touching Buildplate * Support Overhang Angle: 45 degrees * Support Pattern: Gyroid * Support Density: 10% All other settings remain at default levels.