SRT v9.1 Button Box

thingiverse

Button box I made to go on the back of the SRT shifter. Has access port to allow loosening/tightening of the shifter shaft as well. You'll have to flip it around to use it (reverse will be down and to the left instead of right if using the LHD version)To attach use two of DIN7991 M5x20 Assemble with four of DIN7991 M4x15The button plate is symmetrical so if you're RHD, just flip it around either IRL or in the slicer. I used the same board as the one recommended by lebois. I also used the body 2 of the Sequential block mod so that I can connect them with a USB-A to USB-A connector. Refer to that mod for the parts and the female usb plugs. I used the same ones; required some trimming on the plugs and to be held in place with hot glue. used 12mm buttons. this is the dual 90 degree USB connecter I used. It is a foot long. https://www.amazon.com/dp/B08SLW9TT5?ref=ppx_yo2ov_dt_b_product_details&th=1Photos are of the first version where I had the port on the side.