Squirting clown flower

thingiverse

With this costume component, you'll be the life of the party. Inspired by the legendary squirting flower that every clown must wear, here's a Halloween companion that's easy to print and packed with a fun surprise - water! Check out the How I Designed This section for all the details on how to complete your hilarious costume component. Print Settings Printer Brand: RepRap Printer: BCN3D+ Rafts: No Supports: No Resolution: 0.1 or 0.2 Infill: 80% Notes: Important! Print the part with the "face" facing the print bed for the best results. How I Designed This 3D Printing and Post-printing This item prints easily, requiring no supports and three simple parts to assemble. The central part may need a bit of glue, but just one small hole in its center using a thin pin heated with a lighter will do the trick. Be careful where you make that hole - it needs to fit snugly into the channel on the back side. After making the hole, simply clip the part together and ensure it stays tightly in place. Adding the Squirting System Now that we have our component ready, let's get started on the squirting system. We'll need two easy-to-find parts: a plastic syringe (20ml or similar) and a flexible plastic pipe with an outer diameter of 6mm. This is commonly found in gardening stores. First, measure out the length of pipe needed to hide it behind your clothing. Insert one end into the housing on the printed part and the other into the water-filled syringe. The pipe will run through your chest, arm, and hand, where the syringe will do its magic. A tip: use some glue (like superglue) for a tight assembly and to avoid getting wet - check out the videos for more ideas! A Piece of Advice If you notice your friends getting angry or too wet, it's time to move on to another spot!