Squirt v2 GoPro 5 6 7 Variable Angle w/ Lens Guard

cults3d

I did not like how the original variable angle GoPro mount because it did not hold the camera very tight. I never had an issue with it falling out, even after a crash the camera did not move. But still, I rather have a mount that is a bit tighter. So I combined the following files to make what I have now. https://www.thingiverse.com/thing:3495228 and the variable angle base: https://www.thingiverse.com/thing:3425163 Just like the original variable angle mount you will still need to use a m3 x 20mm standoff inside the base. I also remixed the bottom mount so it is a little thicker where it mounts to the frame. The bottom is now 2mm thicker. Update: I did some test with infill and notice a huge weight difference: Infill @ 75% - total weight 15.47g Infill @ 25% - total weight 10.80g Shendrones Squirt Variable Angle Hero Mount - 9.37g For something like the Squirt, I would like to get it as light as possible. With the infill at 75% it had the tightest fit, and with 25% infill it was not bad either. The orginal "Shendrones Squirt Variable Angle Hero Mount" had the least amount of grip on the camera and only weighed 9.37g. So with a tab more weight I am willing to sacrifice 1.5g to make sure my GoPro will NOT fall out. Warning!!! This model is a cut and past job, so some slicer apps might like it. I know for sure Cura was able to handle it. Sorry, I do not know how to properly building 3d models. Update (March 27 2020) After flying the squirt for a while I feel the weight savings with the half case is not worth it because the GoPro is taking a beating where it is exposed. So now I included a FULL case, one with a immortal T mount and one without.