Squirrel Buster Funnel & Multitool

Squirrel Buster Funnel & Multitool

thingiverse

This ridiculous contraption lets you refill a Squirrel Buster bird feeder using only two hands, without setting any parts on the ground except the bag of seed.Features:A small hook for hanging the tool itselfA big post for hanging the feeder's outer shell upside downA funnel for adding bird seedSymmetrically redundant for right/left handed useOnly 30 grams of PLAMy Squirrel Buster Legacy measures 24.9 mm outside the inner cylinder, and 92.2 mm inside the outer cylinder. If yours has the same dimensions, and U-shaped wires on the bottom, then it should be compatible.Usage: Start with the tool hanging from the triangular wire as shown in the photo. Unhang and disassemble the feeder, holding one part in each hand. Lean the big cylinder on its side, and use it to grab the tool and unhook it. Then invert the feeder's outer shell and hang it from a post, freeing up a hand so you can hang the entire feeder for filling.After filling, unhang the feeder and do everything backwards to reassemble. Since you can't lean the filled cylinder on its side, instead use one of the bottom U-shaped wire loops to hook and remove the tool. The whole process is a bit complicated and I'm glossing over some steps, so practice without seed until you figure it out.Printing: Enable tree supports for the small hooks. (The flat bridge area does not need supports.) Consider adding a brim, though my bed adhesion was good enough without one.

Download Model from thingiverse

With this file you will be able to print Squirrel Buster Funnel & Multitool with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Squirrel Buster Funnel & Multitool.